Installation Manual - Model 5 - Tundra Process Solutions Ltd.

More documents

Recommendations

Info

REV C (10-01-10)INSTALLATION MANUAL – D5Appendix C - Historical ConfigurationsThis appendix contains past data and configurations.APPENDIX C – HISTORICAL CONFIGURATIONSC-1
REV C (10-01-10)INSTALLATION MANUAL – D5Page 4:Section 2. Site PreparationThe three pumping unit piers are dimensioned 18” x 18” x 131” and are positioned at a preestablisheddistance from each other. The power unit pier is dimensioned 92” x 60” and is placedtwo to 10 inches from the pumping unit pier.Page 8:Section 4. Unpacking and Pump Unit PreassemblyPumping Unit Final Assembly1. Install the transducer into the cylinder support using two 5/16-inch screws (see Figure 3).OLD DESIGNTransducerMountingscrews (2x)Figure C-2. Installing Celesco Transducer Assembly13. Loosen the transducer mounting bracket to feed the chain over the sprockets of the transducer. When thechain meshes with the sprockets, reattach the bracket and secure with 7/16-inch screws (see Figure 15).MountingbracketOLD DESIGNSprocketsFigure C-3. Passing the Chain through Transducer SprocketsAPPENDIX C – HISTORICAL CONFIGURATIONSC-2
Page 1 and 2:
Installation Manualfor the D5 Pumpi
Page 3 and 4:
REV D (10-22-10)INSTALLATION MANUAL
Page 5 and 6: REV D (10-22-10)INSTALLATION MANUAL
Page 7 and 8: REV A (05-01-09)INSTALLATION MANUAL
Page 15 and 16: REV (-01-)INSTALLATION MANUAL - D5
Page 19 and 20: REV C (10-01-10)INSTALLATION MANUAL
Page 55: REV C (10-01-10)INSTALLATION MANUAL
Page 59: REV C (10-01-10)INSTALLATION MANUAL
show all

Installation Manual - Model 5 - Tundra Process Solutions Ltd.

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?