® SX4e GSM - RACOman.com
® SX4e GSM - RACOman.com
® SX4e GSM - RACOman.com
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Antenna Location & Setup - continued<br />
Connect the Power<br />
1) A protective earth (safety ground) terminal<br />
(screw) marked with this protective earth<br />
symbol is provided on the back of the<br />
<strong>SX4e</strong> unit - see Figure 4.<br />
2) Connect this terminal to a good earth ground<br />
(i.e. a cold water pipe) by means of an 18<br />
gauge or heavier insulated wire. The wire<br />
insulation should be green with a yellow stripe<br />
to indicate that this is a protective earth (safety<br />
ground) connection.<br />
WARNING: The protective earth is to be<br />
installed by a qualified electrician.<br />
3) Connect the Line Cord from the AC power<br />
source to the Power Supply.<br />
!<br />
4) Connect the barrel plug on the Power Supply<br />
to the Power Input port on the side of the<br />
Phonecell.<br />
5) The LED Power Status indicator (located on<br />
the front of the FWT) will turn green immediately<br />
upon connecting to power - see Figure 6.<br />
LED<br />
Power<br />
Indicator<br />
Figure 6<br />
WARNING!<br />
The mounting bracket and<br />
protective earth/ground wire<br />
must be installed on the<br />
Phonecell before power is<br />
applied.<br />
Serial Port<br />
Line<br />
Cord<br />
Protective earth (safety<br />
ground) terminal screw<br />
Figure 4<br />
Fax Port<br />
Power Input Port<br />
Figure 5<br />
Phone Port<br />
Power<br />
Supply<br />
●<br />
●<br />
AC Power<br />
<strong>SX4e</strong> <strong>GSM</strong> 1900 13 USER MANUAL
Change language