® SX4e GSM - RACOman.com

Phonecell SX4e Programming - continued
Enter On-Hook Call Alert Cadence Option
Use the following key sequence to program the on-hook call alert ring
cadence:
Press: # * 30 * * #
Both the on-time and off-time durations are programmed in 100 ms
increments from 1 to 255 (0.1 - 25.5 seconds). If the value is not
between 1 and 255, inclusive, it will be considered invalid. The factory
default is 20 and 40, respectively.
Enter On-Hook Call Alert Frequency Option
Use the following key sequence to program the on-hook call alert ring
frequency:
Press: # * 32 * #
The frequency value is set to 0 for 20 Hz, 1 for 25 Hz, and 2 for 50 Hz.
If the frequency value is greater than 2, it will be considered invalid.
The factory default is 0.
Enter Audio Input Impedance Option
Use the following key sequence to select the audio input impedance:
Press: # * 68 * #
The audio Z value is set to 0 for 600 ohms, 1 for 900 ohms. If the
value is neither 0 nor 1, it is considered invalid. The factory default is 0.
Enter Ring Back Request
Use the following key sequence to request immediate ring back:
Press: # * 13 * #
There is no ring back value to be set; the command activates when the
phone is placed back on-hook.
Enter Restore Factory Defaults Request
Use the following key sequence to request restoration of all factory set
default values (including the SIM PIN auto entry value):
Press: # * 15 * #
There is no restore defaults value to be entered; the command
activates immediately. If a value is entered, it is considered invalid and
the Phonecell will not restore the factory defaults.
Enter Periodic Self Test Option
Use the following key sequence to program periodic self test:
Press: # * 76 * #
The self-test interval is programmed in 1 minute increments from 1 to
65,535. A value of 0 disables periodic self test. If the value is not
between 0 and 65,535, inclusive, it will be considered invalid. The
factory default is 180.
SX4e GSM 1900 41 USER MANUAL