® SX4e GSM - RACOman.com

Phonecell Operation - continued
How to Use Call-Dependent Supplementary Services
Call-dependent supplementary services are those services handled within an
active call. These features are network-dependent. Check with your cellular
provider to determine available features.
Use the following commands to activate the call-dependent supplementary services:
NOTE: is provided by the hookflash function (See the Hookflash
Function section of this manual).
To Release All Held Calls or Set User Determined User Busy For a Waiting Call:
��
��
��
��
��
��
Press: 0 .
To Release All Active Calls and Accept the Held/Waiting Call:
Press: 1 .
To Release a Specific Active Call x:
Press: 1 x (x represents the call ID 1-7).
To Place All Active Calls on Hold and Accept the Held/Waiting Call:
Press: 2 .
To Place All Active Calls on Hold Except Call x:
Press: 2 x (x represents the call ID 1-7).
To Add a Held Call to the Conversation:
Press: 3 .
To Place All Active Calls on Hold and Make the Call to the Specified Phone
Number:
��
Press: PhoneNo .
NOTE: When both a held and a waiting call exist in a conflicting situation, the
above procedures apply to the waiting call.
Call Waiting:
Permits a subscriber to be notified of an incoming call while the subscriber is
engaged in an active or held call. The subscriber can either accept, reject, or
ignore the incoming call.
Activate: 43 # * Deactivate: # 43 #
Interrogate: # 43 # *
Call Hold:
Allows a served subscriber, who is provisioned with this supplementary service, to
interrupt communication on an existing active call and then subsequently, if
desired, re-establish communication. The traffic channel remains assigned to the
subscriber after the communication is interrupted to allow origination or possible
termination of other calls.
SX4e GSM 1900 27 USER MANUAL