display

More documents

Recommendations

Info

IEEE 1394 (FireWire) Pin Signal 1 Twisted-pair B, differential signals 2 Twisted-pair B, differential signals 3 Twisted-pair A, differential signals 4 Twisted-pair A, differential signals 142 Chapter 9 Connector pin assignments
RJ-11 (modem) Pin Signal 1 Unused 2 Tip 3 Ring 4 Unused 5 Unused 6 Unused RJ-11 (modem) 143
Page 1 and 2:
HP EliteBook 2530p Notebook PC Main
Page 3 and 4:
Safety warning notice WARNING! To r
Page 5 and 6:
Table of contents 1 Product descrip
Page 7 and 8:
6 Specifications ..................
Page 9 and 10:
1 Product description Category Prod
Page 11 and 12:
Category Description S4/S5 wake on
Page 13 and 14:
2 External component identification
Page 15 and 16:
Component Description (7) Battery l
Page 17 and 18:
Component Description (5) Presentat
Page 19 and 20:
Display Component Description (1) A
Page 21 and 22:
Rear components Component Descripti
Page 23 and 24:
Left-side components NOTE: Refer to
Page 25 and 26:
Component Description (8) Speaker P
Page 27 and 28:
3 Illustrated parts catalog Serial
Page 29 and 30:
Computer major components Item Desc
Page 31 and 32:
Item Description Spare part number
Page 33 and 34:
Item Description Spare part number
Page 35 and 36:
Display components Item Description
Page 37 and 38:
Mass storage Item Description Spare
Page 39 and 40:
Plastics Kit Item Description Spare
Page 41 and 42:
Sequential part number listing Spar
Page 43 and 44:
Spare part number Description 49256
Page 45 and 46:
4 Removal and replacement procedure
Page 47 and 48:
Grounding guidelines Electrostatic
Page 49 and 50:
Equipment guidelines Grounding equi
Page 51 and 52:
Component replacement procedures Th
Page 53 and 54:
Computer feet The computer feet are
Page 55 and 56:
SIM NOTE: This section applies only
Page 57 and 58:
5. Remove the Bluetooth module (3).
Page 59 and 60:
4. Remove the memory module (2) by
Page 61 and 62:
Description Spare part number ●
Page 63 and 64:
Primary hard drive NOTE: The 4.57-c
Page 65 and 66:
9. Pull the edges of the protective
Page 67 and 68:
5. Remove the two Phillips PM2.0×4
Page 69 and 70:
7. Remove the optical drive bracket
Page 71 and 72:
Before removing the switch cover an
Page 73 and 74:
9. Release the ZIF connector (3) to
Page 75 and 76:
Secondary hard drive NOTE: The 6.35
Page 77 and 78:
6. Remove the secondary hard drive
Page 79 and 80:
14. Remove the secondary hard drive
Page 81 and 82:
Display assembly Description Spare
Page 83 and 84:
7. Remove the two Mylar screw cover
Page 85 and 86:
17. Remove the display panel (3). 1
Page 87 and 88:
Top cover Description Spare part nu
Page 89 and 90:
6. Lift the rear edge of the top co
Page 91 and 92:
3. Release the LED board (3) from t
Page 93 and 94:
Bluetooth module cable NOTE: The Bl
Page 95 and 96:
Remove the system board: 1. Release
Page 97 and 98:
3. Turn the system board rightside
Page 99 and 100: 4. Remove the modem module . Revers
Page 101 and 102: 4. Lift the fan up (3) to remove. R
Page 103 and 104: 3. Remove the heat sink (2). NOTE:
Page 105 and 106: Using Computer Setup Navigating and
Page 107 and 108: Computer Setup menus File menu The
Page 109 and 110: Diagnostics menu Select To do this
Page 111 and 112: Select To do this NOTE: Availabilit
Page 113 and 114: 6 Specifications Computer specifica
Page 115 and 116: Hard drive specifications 250-GB* 2
Page 117 and 118: DVD±RW and CD-RW SuperMulti Double
Page 119 and 120: System interrupt specifications Har
Page 121 and 122: I/O address (hex) System function (
Page 123 and 124: 7 Screw listing This section provid
Page 125 and 126: Where used: 2 screws that secure th
Page 127 and 128: Where used: One screw that secures
Page 129 and 130: Where used: 4 screws that connect t
Page 131 and 132: Torx T8M2.0×6.0 captive screw Colo
Page 133 and 134: Phillips PM2.5×6.0 captive screw C
Page 139 and 140: Phillips PM2.5×11.0 captive screw
Page 141 and 142: Backing up your information Recover
Page 143 and 144: Using f11 CAUTION: Using f11 comple
Page 145 and 146: Backing up your information Recover
Page 147 and 148: 9 Connector pin assignments Audio-i
Page 149: External monitor Pin Signal 1 Red a
Page 153 and 154: Universal Serial Bus Pin Signal 1 +
Page 155 and 156: Requirements for specific countries
Page 157 and 158: Display WARNING! The backlight cont
Page 159 and 160: 4. Disconnect all display panel cab
Page 161 and 162: 15. Remove the backlight cables (1)
Page 163 and 164: Index Symbols/Numerics 1394 port, i
Page 165 and 166: keyboard light button, identifying
Page 167: system date and time 99 System Diag
show all

display

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?