1 2 3 4 5
1 2 3 4 5
1 2 3 4 5
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
1<br />
12<br />
3<br />
4<br />
5<br />
(C) Check the sensor temperature readings<br />
The air conditioner has thermo sensors which are used to control the unit.<br />
IV - 24<br />
4. Service procedures<br />
❏ Each sensor has an address which is made up of the indoor unit address, and the<br />
sensor address. The indoor unit address is used only when several units are<br />
hooked up to one remote controller (group control). If there is only one unit, made<br />
up of one indoor and one outdoor unit, then only the sensor address should be put<br />
in, as shown in the procedure below.<br />
Follow this procedure to display the temperature of each sensor:<br />
a On the remote controller, press both TEST / CHK and CL buttons at the same time for<br />
more than 4 seconds.<br />
AIR FLOW<br />
UNIT<br />
FLAP<br />
TIMER SET<br />
SET CL<br />
A<br />
UNIT No.<br />
R.C. No.<br />
AIM<br />
CODE No.<br />
°C<br />
SWEEP<br />
SET TEMP.<br />
SETTING<br />
b The UNIT No., the address and temperature of the sensors instead of its usual<br />
information will flash on the display.<br />
ON •<br />
OFF •<br />
❏ Following example shows the UNIT No. (Indoor unit address) is fixed at 01– 01.<br />
❑ In case of group control, select the UNIT NO. (Indoor unit address) which you want<br />
to check with UNIT button.<br />
❏ Each time you press the , (SET TEMP.) button you can select a different<br />
sensor, and the display shows the sensor address and temperature as shown<br />
below.<br />
NOTE<br />
AIR FLOW<br />
UNIT<br />
FLAP<br />
TIMER SET<br />
SET CL<br />
UNIT No.<br />
R.C. No.<br />
MONITOR<br />
CODE No.<br />
SETTING<br />
DATA<br />
ON •<br />
OFF •<br />
MODE<br />
SET TEMP.<br />
FAN SPEED<br />
TEST / CHK<br />
MODE<br />
SET TEMP.<br />
FAN SPEED<br />
TEST / CHK<br />
0356_M_I<br />
Do not press TIMER SET button during the procedure.<br />
UNIT No. (Indoor unit address)<br />
Sensor address<br />
Sensor temperature °C<br />
0357_M_I