1 2 3 4 5
1 2 3 4 5
1 2 3 4 5
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
1<br />
12<br />
3<br />
4<br />
5<br />
IV - 34<br />
4. Service procedures<br />
i Select the code No. 14 to set group setting with the , (SET TEMP) button.<br />
j Set the No. of group setting as shown below with the , ( ) button.<br />
AIR FLOW<br />
UNIT<br />
FLAP<br />
TIMER SET<br />
SET CL<br />
UNIT No.<br />
R.C. No.<br />
CODE No.<br />
SETTING<br />
SET DATA<br />
ON •<br />
OFF •<br />
Nos. of group setting.<br />
0 : Standard system (except group<br />
control)<br />
1 : Main indoor unit in case of group<br />
control<br />
2 : Sub indoor unit in case of group<br />
control<br />
99: No setting (at factory shipment)<br />
k Press the SET button.<br />
UNIT No., CODE No. 14, SETTING and SET DATA change from flashing to ON state.<br />
l If you made a mistake, press the CL button so that setting returns to the initial state.<br />
m Press the TEST / CHK button to finish this mode.<br />
The display is disappeared.<br />
MODE<br />
SET TEMP.<br />
FAN SPEED<br />
TEST / CHK<br />
0371_M_I<br />
n Confirm the indoor unit address (UNIT No.) with the UNIT button after pressing the ON<br />
/ OFF button.<br />
o Finally, remove the short circuit of DISP PIN.<br />
And in case of group control, be sure to restore the branch wiring to its original wiring.<br />
In case of remote controller–less system, remove the remote controller.
Change language