1 2 3 4 5

1
12
3
4
5
IV - 30
4. Service procedures
e Set the required new indoor unit’s No. by pressing the , ( ) button.
AIR FLOW
UNIT
FLAP
TIMER SET
SET CL
R.C. No.
CODE No.
SETTING
SET DATA
MODE
FAN SPEED
f Press the SET button.
UNIT No, SET DATA (0008) and SETTING changes from flashing to ON state.
g If you made a mistake, press the CL button.
ON •
OFF •
SET TEMP.
TEST / CHK
0364_M_I
h Finally, press the TEST / CHK button.
Ex: UNIT No. 3-6: currently registered indoor unit address
Required new indoor No.8: SET DATA
i If you want to change the indoor unit address of the other R.C. No., follow the step a
to h in the same way.
* In this case, UNIT No. 3 – 6 (current)
≠
3 – 8 (NEW : after pressing the
TEST / CHK button)