Embroidery Basics Articles
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
➢<br />
➢<br />
Connect Blocks:<br />
What type of stitch will connect the sub layers of the current block.<br />
With Running Stitches:<br />
Connect branches or layers with running stitches<br />
With Jump Stitch:<br />
Connect branches or layers with a single stitch.<br />
In case of Jump:<br />
Insert actual Jump:<br />
If the Connect with Jump is selected, this option allows the insertion of an actual JUMP<br />
command instead of the Normal stitch.<br />
Trim Controls:<br />
Trim Always:<br />
Cut the thread between all layers. Be aware, this will cause the machine to cut the thread<br />
between the layers of underlay and top stitching.<br />
Trim if Distance is greater than:<br />
Causes a trim to occur is the distance between the branches or layers is greater in 1/10 mm<br />
than the defined setting.<br />
Never Trim:<br />
Do not trim between the layers or branches, this is the normal setting.<br />
Handle Tie Automatically:<br />
The system will insert tie stitches between layers or branches depending on the options set in<br />
the Manual Tie Control<br />
• Manual Tie Control.<br />
➢<br />
➢<br />
Tie In Before Block<br />
Off: Do Not create a tie at the beginning of all branches or<br />
layers.<br />
Always Tie in: Create tie stitch at the beginning of all layers<br />
and branches<br />
After Trim/Color Change: Create tie stitch only after the<br />
system has inserted a trim or color change<br />
Distance from previous block is greater than: Create a tie<br />
stitch if the distance between layers or branches exceeds the<br />
specified value in 1/10 mm.<br />
Tie Off After Block<br />
Off: Do Not create a tie off at the end of all blocks or layers.<br />
Always Tie Off: Create tie stitch at the end of all layers and branches<br />
Before Trim/Color Change: Create tie stitch before a system inserted trim or color change<br />
Distance from previous block is greater than: Create a tie stitch if the distance between<br />
layers or branches exceeds the specified value in 1/10 mm.