Guide to configuring eduroam using a Cisco wireless controller Best ...

More documents

Recommendations

Info

WLC supports NTP, which is set at another location. NTP server is usually the nearest router. If not another NTP server can be used, as in this example If a previously autonomous access point has been converted to a lightweight access point and the application has not specified an SSC for the access point, the SSC or the MIC (the MAC address for the access point’s Ethernet address) must be entered before the access point is permitted to connect. This will be found under Security → AAA → AP Policies. 28
3.2.5 Further details Once a access point has been connected it will be possible to see the SSID which has been created. Under Management one may wish to configure a number of things, such as SNMP parameters (which shall be used in communication with, among other things, the WCS), HTTP, Telnet, administration users, logging, and so on. Regarding timeout values for EAP authentication, the section “Manipulating EAP Timers” in the Cisco document http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a0080665d18.shtml gives some valuable recommendations that should be considered. 29
Page 1 and 2: Guide to configuring eduroam using
Page 3 and 4: Table of Contents Executive Summary
Page 5 and 6: Executive Summary UFS127 is a UNINE
Page 7 and 8: 1 Network planning 1.1 Necessary co
Page 9 and 10: established by means of the Managem
Page 11 and 12: http://www.cisco.com/en/US/tech/tk7
Page 13 and 14: authentication can be completed. He
Page 15 and 16: Management Interface Netmask: 255.2
Page 17 and 18: 3.2 Further configuration via web b
Page 19 and 20: Path: Security → RADIUS → Accou
Page 21 and 22: Under General, the WLAN can be enab
Page 23 and 24: Security Layer 3 shall be “None
Page 25 and 26: What one selects under QoS depends
Page 27: 3.2.4 Connecting access points Afte
Page 31 and 32: operating and/or the cabling is not
Page 33 and 34: A. Configuration using autonomous a
Page 35 and 36: A.3 RADIUS configuration Go to SECU
Page 37 and 38: B. Configuring Microsoft RADIUS ser
Page 39 and 40: Step 3: Adding clients in IAS The c
Page 41 and 42: Step 5: Connection Request Policies
Page 43 and 44: Create a Connection Request Policy
Page 45 and 46: • Click on “OK”, then “Next
Page 47 and 48: User ola.nordmann was granted acces
Page 49 and 50: • Type in a “Friendly Name”
Page 51 and 52: Step 4: Connection Request Policies
Page 53 and 54: Step 5: Network Policies Remote Acc
Page 55 and 56: Step 7: Logging NPS adds log entrie
Page 57 and 58: oot@sirius:~/tmp$ openssl x509 -noo
Page 59 and 60: Glossary CAPWAP Control And Provisi

Guide to configuring eduroam using a Cisco wireless controller Best ...

Create successful ePaper yourself

Delete template?

Save as template?