Configuration Manual Synchronous Motors 1FT6 - Siemens ...

Motor Components (Options)
4.3 Motors with DRIVE-CLiQ
4.3 Motors with DRIVE-CLiQ
Cables
Motors with DRIVE-CLiQ have a sensor module that includes the encoder evaluation, the
motor temperature sensing and an electronic rating plate.
This sensor module instead of the signal connector and has a 10-pin RJ45-plus socket.
Caution
The sensor module contains motor and encoder-specific data as well as an electronic rating
plate. This is the reason that this sensor module may only be operated on the original motor
- and may not be mounted onto other motors or replaced by a sensor module from other
motors.
The sensor module has direct contact to components that can be destroyed by electrostatic
discharge (ESDS). Neither hands nor tools that could be electrostatically charged may come
into contact with the connections.
For all encoder types (incremental encoder, absolute value encoder, resolver), the same
DRIVE-CLiQ cable is used.
The following cable should be used to connect an encoder:
Table 4-3 Prefabricated cable
6FX ☐ 002 - ☐DC☐☐ - ☐☐☐ 0
↓
↓
5 MOTION-
CONNECTⓇ500
8 MOTION-
CONNECTⓇ800
↓↓↓
Length
Max. cable length 100 m
Max. cable length 50 m
Only prefabricated cables from Siemens (MOTION-CONNECT) may be used.
Additional technical data and length code, refer to Catalog, Chapter "MOTION-CONNECT
connection system"
1FT6 synchronous motors
4-4 Configuration Manual, (PFT6), Edition 12.2004, 6SN1197-0AD12-0BP0