z/VM: CP Commands and Utilities Reference - z/VM - IBM

FILENAME
identifies the file names specified, or defaulted to, on the TRSAVE command.
RECEIVER
identifies the users specified, or defaulted to, as the TO userid on the TRSAVE
commands. Each userid listed in the column is the only user authorized to read
this system trace file.
KEEP
identifies the maximum number of files that CP keeps each time this trace is
active.
SIZE
identifies the maximum size, in 4 KB pages, for each of the files created when
this trace is active.
FRAMES
identifies the amount of real storage frames set aside for an in-storage-wrap of
the DEFERIO trace. The real storage frames are allocated from the system
dynamic paging area when the traceid is enabled or, for trace table data, when
TRSAVE CP ON is issued. Blanks are displayed if the trace is not a DEFERIO
trace.
FILLED
identifies the amount of those real storage frames that are filled with trace data.
Blanks are displayed if the trace is not a DEFERIO trace. nnnnn will not exceed
mmmmm-1 because one frame is set aside as the current frame being filled.
When nnnnn reaches mmmmm-1, the displayed value of nnnnn remains at that
level until the traceid is disabled.
DEFERIO
indicates that no trace data is recorded on DASD until the traceid is disabled or,
for trace table data, until TRSAVE CP OFF is issued. Blanks are displayed if the
trace is not a DEFERIO trace.
When ALL is specified, the above information is displayed for all existing traceids
and for CPTRACE when it is active.
Response 2:
The following message is displayed when a class A, C, or E user issues QUERY
TRSAVE ID traceid for a trace ID that is not defined.
Traceid traceid is not defined.
Response 3:
The following message is displayed when a class G user issues QUERY TRSAVE
ID traceid for a trace ID that is not defined or when the user is not authorized to
view information for that particular traceid.
Traceid traceid is not tracing for your virtual machine.
Response 4:
The following message is displayed when the user issues QUERY TRSAVE ALL but
no trace IDs have been defined.
No traceids defined.
Response 5:
QUERY TRSAVE
Chapter 2. CP Commands 1049