z/VM: CP Commands and Utilities Reference - z/VM - IBM

INSTALL
HCP8370E PLEASE CORRECT THE INDICATED
PROBLEMS AND RERUN THE INSTALL
EXEC
HCP8371I LOADING component ...
HCP8372R PLEASE MOUNT VOLUME volno ON
TAPE DRIVE vaddr THEN PRESS
ENTER TO CONTINUE
HCP8373E DDR HAS REPORTED {AN ERROR | A
RETURN CODE OF 2 | A RETURN
CODE OF 4 (PERMANENT TAPE OR
DASD I/O ERROR)} CHECK DDR
$MSGLOG ON THE 2CC DISK FOR
MORE INFORMATION
HCP8376E INSTALL EXEC ENDED IN ERROR
HCP8378R TAPE addr IS NOT READY. PLEASE
READY THE DRIVE AND PRESS
ENTER TO CONTINUE OR TYPE EXIT
TO END command
HCP8379E DRIVE vaddr FAILED THE EXEC'S
REWIND COMMAND WITH RC = rc
HCP8380I RESTORING MINIDISK mdisk TO [label |
MINIDISK label]
HCP8381I CHECKING TAPE VOLUME NUMBER
FOR DRIVE vaddr
HCP8382E VOLUME volno IS NOT A DDR TAPE
HCP8383R WRONG TAPE MOUNTED ON DRIVE
addr. PLEASE MOUNT VOLUME volno
ON DRIVE addr. THEN PRESS ENTER
TO CONTINUE OR TYPE EXIT TO END
INSTALL
HCP8386E DDR MODULE DOES NOT EXIST ON
SYSTEM
HCP8387E INSTALL EXEC MUST BE EXECUTED
FROM THE 2CC DISK
HCP8388I CHECKING STATUS OF DRIVES
1844 z/VM: CP Commands and Utilities Reference
HCP8395E A TARGET MDISK WAS NOT
PROVIDED. ATTEMPT TO DEFINE
TDISK FOR TARGET DISK FAILED.
HCP8401E INSTALL EXEC MUST BE RUN ON A
FULL SCREEN TERMINAL WITH AT
LEAST 20 LINES
HCP8428I TOTAL PERCENT LOADED -> percent
HCP8429E INVALID SYNTAX. OPTIONS MAY NOT
FOLLOW A ’)’
HCP8431E THE mdisk DISK MUST BE IN R/W
MODE
HCP8433I INSTALL PROCESSING CONTINUES
HCP8434I comp HAS BEEN SUCCESSFULLY
LOADED
HCP8435E 2CC DISK IS FULL.
HCP8437E TOO MANY ARGUMENTS: options
HCP8438E TOO FEW ARGUMENTS: options
HCP8439E diskaddr IS NOT ON THE DDR TAPE
HCP8441I diskaddr HAS BEEN RESTORED TO
MINIDISK mdisk
HCP8442E YOU CANNOT RESTORE THE 2CC
DIRECTLY TO THE 2CC DISK
HCP8464R YOU HAVE SPECIFIED THE SAME
DISK FOR RECOVERY AS YOUR
TARGET. THIS WILL OVERLAY ANY
CHANGES MADE TO THE DISK. DO
YOU REALLY WANT TO CONTINUE?
ENTER (Y)ES OR (N)O