z/VM: CP Commands and Utilities Reference - z/VM - IBM

v Hot I/O rates are being controlled by
HCD
v Dynamic I/O changes are not
allowed for CSS nn
HCP6817E You must specify an existing CP
command for this alias
HCP6819E A dynamic I/O command is currently
executing for user userid
HCP6830I volid is currently attached to SYSTEM.
Detach the device from SYSTEM and
try this command again.
HCP6834E Command parameter list length is too
{small|large}.
HCP6835E The variations of this message are as
follows:
v Offset to command name is
negative.
v Offset to command name is zero.
v Offset to command name exceeds
parameter list length.
v Offset to command name overlays
parameter list fields.
v Offset to subcommand name is
negative.
v Offset to subcommand name
exceeds parameter list length.
v Offset to subcommand name
overlays parameter list fields.
v Offset to alias name is negative.
v Offset to alias name exceeds
parameter list length.
v Offset to alias name overlays
parameter list fields.
HCP6836E {Command|Subcommand|Alias} name
extends beyond end of parameter list.
HCP6838E {Command|Subcommand} name
abbreviation is too large.
HCP6839E New command or abbreviation
duplicates an existing one (command)
HCP6840E The variations of this message are as
follows:
v You specified SUBCMD without SET
or QUERY
v You specified QUERY VIRTUAL
without SUBCMD
HCP6841E The variations of this message are as
follows:
v You specified more than one IBM
class.
v You specified IBM class H, which is
reserved for IBM use only.
HCP6842E Cannot find existing CP command for
new alias
HCP6843E All versions of the command must
have the same logon value
DEFINE
HCP6844E All versions of the command must
have the same {PROC value|entry point
name|entry point address|minimum
abbreviation|SILENT setting}
HCP6845E You must specify {an entry point
name|a privilege class[other than 0]|an
IBM class [other than 0]}
HCP6846E Requested entry point name is not {an
external label in the nucleus|at the
address indicated}
Chapter 2. CP Commands 117