Software Manual for the R&S ZVL-K1 - Rohde & Schwarz

Using Limit Lines and Display Lines – LINES Key R&S ZVL-K1
Insert Value Above
Creates an empty line above the selected data point to enter a new data point. This softkey
corresponds to the Insert button in the dialog box.
It is also possible to add a data point at the end of the list, if the focus is set below the last entry
line of the list.
The data points are entered in ascending order (two repeated frequencies/time values are
permitted). If the entered values are not in accordance with the ascending order rule, an error
message is displayed and the values are discarded.
Delete Value
Deletes the selected data point (x and y value). All succeeding data points are shifted up
accordingly. This softkey corresponds to the Delete button in the dialog box.
The softkey is only available if an existing value is selected.
Save Limit Line
Edit
Saves the currently edited limit line under the name defined in the Name field.
Opens a submenu to edit limit lines. For details see also "Limit Lines" on page 3.113 and "To
edit an existing limit line" on page 3.112.
� Remote: For details refer to chapter "Remote Control – Commands", section "Definition of the limit
line".
Copy to
Copies the data of the selected limit line and displays it in the Edit Limit Line dialog box. If the
limit line is edited and saved under a new name, a new limit line can be easily generated by
parallel translation or editing of an existing limit line.
For details see also "Limit Lines" on page 3.113 and "To create a new limit line based upon an
existing limit line" on page 3.112.
� Remote: CALC:LIM3:COPY 2
Delete
Deletes the selected limit line.
� Remote: CALC:LIM3:DEL
Display Lines
Opens a submenu to enable, disable and set display lines. Which softkeys are available
depends on the display mode (frequency or time range). For details see also "Display Lines" on
page 3.113 and "To work with display lines" on page 3.109.
1303.6573.42 3.116 E-5