Software Manual for the R&S ZVL-K1 - Rohde & Schwarz

WiMAX, WiBro Measurements (Option K93) R&S ZVL-K1
– Spectrum FFT (see Spectrum FFT softkey)
– Constellation vs Symbol (see Constell vs Symbol/Carrier softkey)
– Constellation vs Carrier (IEEE 802.16–2004 OFDM only, see Constell vs Symbol/Carrier
softkey)
– Conditional Cumulative Distribution Function (see CCDF softkey)
– Bit Stream (see Bitstream softkey)
frequency sweep measurements
– Spectrum Mask (see Spectrum IEEE/ETSI softkey)
– Spectrum ACP/ACPR (see ACPR Abs/Rel softkey)
For current restrictions refer to Current restrictions to the IEEE 802.16e–2005 OFDMA/WiBro signal to
be analyzed.
The measurement result display is divided into two panes:
Measurement settings
Result displays
The results can be displayed in form of a list or a graph (see also Display List/Graph softkey).
– Result summary list
– Result display graph
Current restrictions to the IEEE 802.16e–2005 OFDMA/WiBro signal to be analyzed
standard
– IEEE 16–2004/Cor1–2005, IEEE 802.16e–2005, OFDMA Physical Layer Mode, 1 October
2004/28 February 2006
– IEEE 16–2004/Cor1–2005, IEEE 802.16e–2005 based WiBro
FFT sizes
The FFT sizes 128, 512, 1024 and 2048 are supported.
subframes
– Either a DL subframe or a UL subframe can be analyzed at one point in time.
– One DL–PUSC zone per DL subframe is supported.
– One DL–FUSC zone immediately following the first mandatory DL–PUSC zone is supported
(DL subframe).
– One UL–PUSC zone per UL subframe is supported.
– The subframes have to be separated by sufficient power off gaps.
segments
The first mandatory DL–PUSC zone must contain exclusively one segment. The assignment of
subchannel groups to this segment is not restricted.
symbols
The signal to be analyzed must contain at least two OFDMA data symbols. More OFDMA data
symbols will improve the accuracy of the measurement results.
burst
1303.6573.42 3.416 E-5