Software Manual for the R&S ZVL-K1 - Rohde & Schwarz

R&S ZVL-K1 Bluetooth Measurements (Option K8)
Ref Level Offset
For details refer to the Ref Level Offset softkey in the amplitude menu of the base unit.
Ref Level Position
For details refer to the Ref Level Position softkey in the amplitude menu of the base unit.
Input 50 Ω / 75 Ω
For details refer to the Input 50 Ω / 75 Ω softkey in the amplitude menu of the base unit.
Softkeys of the bandwidth menu (Bluetooth mode)
The following table shows all softkeys available in the bandwidth menu in Bluetooth mode (PWR BW
key). It is possible that your instrument configuration does not provide all softkeys. If a softkey is only
available with a special option, model or (measurement) mode, this information is delivered in the
corresponding softkey description.
Command
Meas Time Manual
Meas Time Auto
Sweeptime Manual
Sweeptime Auto
Res BW Manual
Res BW Auto
Video BW Manual
Video BW Auto
Filter Type
Meas Filter
Meas Time Manual
(Output Power, Modulation Char, Init Carr Freq Tol, Carr Freq Drift, Rel TX Power, Carr Freq
Stability, Diff Phase)
Opens an edit dialog box to enter the measurement time. The valid value range is 1 µs to
(400001 / points per symbol) µs.
� Remote: CONF:BTO:SWE:TIME 10MS
Meas Time Auto
(Output Power, Modulation Char, Init Carr Freq Tol, Carr Freq Drift, Rel TX Power, Carr Freq
Stability, Diff Phase)
Activates the automatic calculation of the measurement time. The automatic sweep time
corresponds to the settings defined in the RF Test Specification. By default, the automatic
sweep time calculation is activated.
� Remote: CONF:BTO:SWE:TIME:AUTO ON
1303.6573.42 3.157 E-5