28.12.2012 Views

Software Manual for the R&S ZVL-K1 - Rohde & Schwarz

Software Manual for the R&S ZVL-K1 - Rohde & Schwarz

Software Manual for the R&S ZVL-K1 - Rohde & Schwarz

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

CALCulate Subsystem R&S <strong>ZVL</strong>‑<strong>K1</strong><br />

CALCulate:LIMit:ESPectrum Subsystem<br />

The CALCulate:LIMit:ESPectrum subsystem defines <strong>the</strong> power classes used in Spectrum Emission<br />

Mask measurements.<br />

Commands of <strong>the</strong> CALCulate:LIMit:ESPectrum subsystem<br />

– CALCulate:LIMit:ESPectrum:PCLass[:EXCLusive]<br />

– CALCulate:LIMit:ESPectrum:PCLass:MINimum<br />

– CALCulate:LIMit:ESPectrum:PCLass:MAXimum<br />

– CALCulate:LIMit:ESPectrum:PCLass:COUNt<br />

– CALCulate:LIMit:ESPectrum:PCLass:LIMit[:STATe]<br />

CALCulate:LIMit:ESPectrum:PCLass[:EXCLusive]<br />

This command sets <strong>the</strong> power classes used in <strong>the</strong> measurement. It is only possible to use<br />

power classes <strong>for</strong> which limits are defined. Also, ei<strong>the</strong>r only one power class at a time or all<br />

power classes toge<strong>the</strong>r can be selected.<br />

The numeric suffixes and are irrelevant <strong>for</strong> this command.<br />

Parameter<br />

ON | OFF<br />

Example<br />

CALC:LIM:ESP:PCL1 ON<br />

Activates <strong>the</strong> first defined power class.<br />

Characteristics<br />

*RST value: –<br />

SCPI: con<strong>for</strong>m<br />

Mode<br />

A, CDMA, EVDO<br />

CALCulate:LIMit:ESPectrum:PCLass:MINimum<br />

This command sets <strong>the</strong> lower limit level <strong>for</strong> one power class. The unit is dBm. The limit always<br />

start at – 200 dBm, i.e. <strong>the</strong> first lower limit can not be set. If more than one power class is in use,<br />

<strong>the</strong> lower limit must equal <strong>the</strong> upper limit of <strong>the</strong> previous power class.<br />

The numeric suffix at PCLass denotes <strong>the</strong> power class to be defined.<br />

The numeric suffixes and are irrelevant <strong>for</strong> this command.<br />

Parameter<br />

<br />

Example<br />

CALC:LIM:ESP:PCL2:MIN -40 dBm<br />

Sets <strong>the</strong> minimum power value of <strong>the</strong> second power class to -40 dBm.<br />

Characteristics:<br />

*RST value: –<br />

SCPI: con<strong>for</strong>m<br />

Mode<br />

A, CDMA, EVDO<br />

1303.6573.42 4.44 E-5

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!