Downloading - Weber Marking Systems

Configuring Legi Print Drivers
Appendix D: True Type Font Support
You must tell Legi what fonts are downloaded and resident
in the printer. Do this by using the Fonts property page of
the Legi print driver. Note that the fonts you want to use
must have previously been downloaded to the printer using
the Sato Memory Card Manager.
You will need administrative access to the computer to
perform the following procedures.
Add Font Procedure
1. Display the property pages of the Legi driver you are
using and select the Fonts tab.
2. Select the TrueType font you want to access from the
list Installed Computer Fonts.
3. Choose the memory card slot that was used when you
downloaded the font using the Sato Memory Card
Manager.
4. Select it in the Memory Card list.
5. Enter the font ID in the Font ID edit control.
NOTE: This is the value that was assigned by the
printer when you downloaded the font using the Sato
Memory Card Manager.
6. Enter the point size of the font that was downloaded.
7. Press the Add To Downloaded List button.
The font will be added to the Downloaded Printer
Fonts list.
8. Press OK when you are done adding fonts.
Delete Font Procedure
1. Select the font from the Downloaded Printer Fonts list.
2. Press the Remove From List button.
You will see the font disappear from the list.
3. Press OK when you are done removing fonts.
Use the Sato Memory Card Manager to delete the font from
the printer.
Legitronic User Manual (v3.4) 218