Downloading - Weber Marking Systems

Notes
Configuring Legi Print Drivers
Appendix E: Graphics Support
8. Locate the converted file according to the directory
paths setup under Options, Directories.
9. Send the file to the printer using a communications
program or DOS.
Use the front panel setup to display the memory module
contents. Do this to verify that the graphic was stored in the
printer.
You must tell Legi what graphics are downloaded and
resident in the printer. Do this by using the Graphics
property page of the Legi print driver. Note that the
graphics you want to use must have previously been
downloaded to the printer using the Zebra Tools 3.1.
You will need administrative access to the computer to
perform the following procedures.
Add Graphic Procedure
1. Display the property pages of the Legi driver you are
using and select the Graphics tab.
2. Enter the name of the graphic as it is used by Legi in
the Filename edit control.
NOTE: Do not include the drive letter or path.
For example: In a Legi graphic field, the name might
be C:\Graphics\Logo.pcx. Enter only Logo.pcx in this
edit control.
3. Enter the graphic filename in the Download Filename
edit control.
NOTE: This is the name that was used when you
downloaded the font to the printer using Zebra Tools
3.1. You do not need to enter the .GRF extension.
4. Select the memory location that was used when you
downloaded the font (usually B:). NOTE: Check that
R: was not used. R: is used for label data and is cleared
at the beginning of every label printed.
Legitronic User Manual (v3.4) 226