Downloading - Weber Marking Systems

Configuring Legi Print Drivers
Appendix D: True Type Font Support
You must tell Legi what fonts are downloaded and resident in the
printer. Do this by using the Fonts property page of the Legi print
driver. Note that the fonts you want to use must have previously been
downloaded to the printer using the Datamax Print Driver.
You will need administrative access to the computer to perform the
following procedures.
Add Font Procedure
1. Display the properties page of the Legi driver you are using and
select the Fonts tab.
2. Select the TrueType font you want to access in the printer from the
list Installed Computer Fonts.
3. Enter the font filename in the Download Filename edit control.
NOTE: This is the name that was used when you downloaded the
font to the printer using the Datamax Print Driver.
4. Enter the font ID in the Font ID edit control.
NOTE: This is the value (e.g. S50) that was assigned when you
downloaded the font using the Datamax Print Driver.
5. Choose the location (e.g. F) that you used when you downloaded
the font. Select it from the Location list.
6. Press the Add To Downloaded List button.
The font is added to the Downloaded Printer Fonts list.
7. Press OK when you are done adding fonts.
Delete Font Procedure
1. Select the font from the Downloaded Printer Fonts list.
2. Press the Remove From List button. You will see the font
disappear from the list.
3. Press OK when you are done removing fonts.
Use the Datamax Print Driver to also delete the font from the printer.
Legitronic User Manual (v3.4) 221