You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Rear panel<br />
Panel Descriptions/ Making Connections<br />
* To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the power on all devices<br />
before making any connections.<br />
1. POWER switch<br />
This turns the power on/off.<br />
2. AC adaptor jack<br />
Connect the supplied AC adaptor to this jack.<br />
* To prevent the inadvertent disruption of power to your unit<br />
(should the plug be pulled out accidentally), and to avoid<br />
applying undue stress to the AC adaptor jack, anchor the<br />
power cord using the cord hook, as shown in the illustration.<br />
3. MIDI connectors (IN, OUT)<br />
These connectors are used when you want to use the D2<br />
to play external sound generating devices, or use an<br />
external sequencer to play the D2’s sound generator; or<br />
Turning On/Off the Power<br />
* Once the connections have been completed, turn on power to<br />
your various devices in the order specified. By turning on<br />
devices in the wrong order, you risk causing malfunction and/<br />
or damage to speakers and other devices.<br />
1. Make sure that all volume controls on the D2 and<br />
connected devices are set to “0.”<br />
2. Turn on the D2’s [POWER] switch.<br />
3. Turn on the device connected to the OUTPUT Jacks.<br />
4. Adjust the volume levels for the devices.<br />
1 2 3 4 5 6<br />
AC Adaptor<br />
Cord hook<br />
To Mixer, Amplifier<br />
when you want to save or load D2 settings.<br />
* For details concerning MIDI devices, refer to Chapter 8.<br />
System Settings and MIDI Applications (p. 73).<br />
4. OUTPUT jacks (L, R)<br />
Connect these jacks to your mixer or amp.<br />
5. Headphone jack<br />
This jack accepts connection of a set of stereo<br />
headphones. Sound will still be output from the<br />
OUTPUT jacks even while headphones are connected.<br />
6. Security Slot ( )<br />
http://www.kensington.com/<br />
* This unit is equipped with a protection circuit. A brief interval<br />
(a few seconds) after power up is required before the unit will<br />
operate normally.<br />
Turning off the power<br />
Stereo Headphones<br />
Before switching off the power, lower the volume on each of<br />
the devices in your system and then TURN OFF the devices<br />
in the reverse order to which they were switched on.<br />
11
Change language