Owner's Manual - Roland

18. Flanger (Add Metallic Resonance to the Sound)
fig.MFXFLN
Chapter 4. Applying Effects to the Sound (Effects)
This creates a sharp and mechanical sound. It can add a metallic resonance to the sound, or produce an effect that sounds like an
jet airplane taking off and landing.
Screen Parameter Explanation Value
PRE DELAY
Specifies the time from the original sound 0.0–100
(Pre Delay Time) until the flanger sound is heard.
DEPTH Specifies the depth of modulation. 0–127
FEEDBACK
(Feedback Level)
Specifies the proportion of the flanger
sound that is fed back into the input.
RATE Specifies the rate of modulation. If a note
value or measure is selected as the value
of this parameter, the Rate will synchronize
with the BPM of the pattern at intervals
of the specified note value or
measure.
PHASE Adjusts the width of the sound. As this
setting is increased, the left/right spread
of the sound will increase.
FILTER TYPE Determines the type of filter that will be
applied to the flanger sound.
CUTOFF
(Cutoff Frequency)
BALANCE
(Effect Balance)
0–98 (%) Y
0.1–10.0 (Hz), notes (*1), measures (*2) X
* 1: 16 (16th note), 8T (8th note triplets), 16. (dotted 16th note), 8 (8th note), 4T (quarter note triplets), 8. (dotted 8th note), 4 (quarter note), 2T (half note
triplets), 4. (dotted quarter note), 2 (half note), 1T (whole note triplets), 2. (dotted half note), 1 (whole note)
* 2: 2M (2 measures), 3M (3 measures), 4M (4 measures), 8M (8 measures), 16M (16 measures)
0–180
Specifies the cutoff frequency of the filter. 200 (Hz)–8.00 (kHz)
Adjusts the volume balance between the
original sound and the flanger
sound.With a setting of “0,” no flanger
sound will be output.
OUTPUT LEVEL Specifies the output volume from the stereo
flanger.
OFF (a filter will not be used),
LPF (the frequency range above the cutoff
frequency will be cut),
HPF (the frequency range below the cutoff
frequency will be cut)
0–100 (%)
0–127
53
Chapter 4