Pure-Flo®

PURE-FLO ® BIO-TEK ® ® PURE-FLO ZERO STATIC “T” 17 17
A
A
The Zero Static “T”* reduces dead legs in a
process system by welding the body directly
into the distribution loop. This process fabrication
is frequently used as a point-of-use valve.
TUBING SIZE
Inch 0.50 0.75 1.00 1.50 2.00 3.00 4.00
(DN) 4 15 20 25 40 50 80 100
.25, .375,
.50 8, 10, 15 X X X X X X X
0.50 15 X X X X X X X
0.75 20 X X X X X X
1.00 25 X X X X X
1.50 40 X X X X
2.00 50 X X X
SIZE RANGE
1/4"–2" main valve by 4" header maximum
(DN 15–50 valve by DN 100 tube maximum)
PRESSURE/TEMPERATURE
See General Engineering Data section, page 75.
BODY MATERIAL
• 316L Stainless Steel Wrought, ASTM-A-479,
1/4"–2" (DN 8–50)
END CONNECTIONS
Buttweld:
• 14, 16, 18, 20 Gauge O.D. Tubing
• DIN/ISO Ends
Quick Disconnect:
• Tri-Clover Tri-Clamp ®
• Cherry Burrell “S”, “Q”, and “I” line ®
• Others available upon request
DIMENSIONAL ENVELOPE
• When utilizing the Advantage actuator,
dimension “H” on page 33 should be used.
• When utilizing manual bonnet assemblies,
dimensional information on pages 26 and 76
should be used.
• For valve body end to end dimensions,
contact the factory.
* The Zero Static “T” fabrication is supplied with a tube
spool piece as a standard; “U” Bend type configurations
are available upon request.
4 Chart applies only to
O.D. tubing.
PROCESS FABRICATIONS