Manual - Surveillance System, Security Cameras, and CCTV ...

90
1.12.2 PTZ Idle Protection
When the PTZ remains stationary for a certain time, the PTZ can automatically activate the scan mode,
move to the designated preset point, or start the preset tour.
1. In the Camera Mapping Setup dialog box (Figure 1-50), select PTZ Inactivity.
2. Set the idle time after which to start the protection mode.
3. Select Auto, Preset, Multi Position Tour or Tour Schedule as protection mode.
Setting Multi Position Tour
You can create a PTZ tour with up to 64 preset points. Note the number of preset points depends on
your PTZ capacity.
1. Select Multi Position Tour on the Camera Mapping Setup dialog box (Figure 1-50), and click the
Setting button. This dialog box appears.
Figure 1-71
2. Select a Preset as a start point.
3. Set the Dwell Time that the PTZ will remain in a preset.
4. Click Add and repeat Steps 2-3 to build more points in the tour.
Setting Tour Schedule
When the PTZ camera remains stationary for a certain time, the camera will start the defined
behaviors, such as activating the auto pan or returning the designated preset, in the defined time
frames.