Manual - Surveillance System, Security Cameras, and CCTV ...

1.12.4 PTZ Automation
Other than the PTZ control panel, you can display a Visual PTZ Control Panel on the image.
Figure 1-74
1. To control the PTZ, you must map one channel to the PTZ camera first. For details, see Mapping
PTZ Cameras earlier in this chapter.
2. To access the new control panel, click on the desired Camera Name on the top left corner of
every channel, and select PTZ Automation. A separate PTZ control window appears.
3. To change the panel settings, click the green PTZ button on the top left corner of the PTZ control
window to have these options:
1
Configuring Main System
[PTZ Control Type]
� Type 1: In this mode when you place the mouse arrow on the four directions, ex. north, south,
east, west, the speed indicator of five levels will appear. Click and hold on the required level
of movement and the camera will move as per the specific speed.
� Type 2: In this mode with the mouse click, the PTZ control panel will appear. The movement
of the camera will depend on the speed of the mouse movement.
[Configure]
� Set Color: Changes the color of the panel. Three kinds of colors are available: Red, Green
and Blue.
� Transparent Degree: Adjusts the transparency level of the panel. Ten levels range from 10%
(fully transparent) to 100% (fully opaque).
93