Manual - Surveillance System, Security Cameras, and CCTV ...

134
2.10 Economic Mode
The economic mode helps you reduce the disk space needed to store videos from IP video devices.
Once the economic mode is enabled, you can choose to record key frames only or at a lower frame
rate when no motion is detected or when I/O devices are not triggered. This can significantly reduce
the file size of the recorded events.
Note: The Economic Mode can only be applied to IP cameras.
To set up the economic mode:
1. Click the Configure button (No.14, Figure 1-2), select General Setting, and select System
Configure.
2. Select the Camera Recording Setting tab, and select an IP camera under Camera Name.
3. Under the Rec control section, click the button after Frames/Sec. This dialog box appears.
Figure 2-12
4. Select Enable Economic Mode to enable the economic mode.