Manual - Surveillance System, Security Cameras, and CCTV ...

1.2.1 Configuring Global Recording Parameters
Let’s start with the options on the General Setting tab:
1
Configuring Main System
[Startup] The Startup options instruct the system to enable selected features at system startup.
� Start Monitor: Select one of the following monitor control modes at system startup:
� Monitor All: Allows you to monitor all cameras and I/O (if available) at system startup. It is the
same as to manually click Monitor button (No. 16, Figure 1-2) and select Start All Monitoring.
(For details, see Camera Monitoring later in this chapter).
� Schedule Monitor: Allows you to monitor cameras by schedule. Alternatively you may click
Schedule button (No. 15, Figure 1-2) and select Schedule Start. Refer to Recording
Schedule later in this chapter.
� I/O Monitor: Allows you to monitor all I/O devices. Alternatively you may click the Monitor
button (No. 16, Figure 1-2), and then select I/O Monitoring.
� Camera Monitor: Enables all cameras for monitoring.
Note: To set different recording modes and alert methods for each camera, see Monitor Control in
Adjusting Individual Camera later in this chapter.
� WebCam Server: Allows connection to WebCam Server at startup. (Or click the Network button
(No. 11, Figure 1-2) and select WebCam Server.)
� Connect to VSM: Allows connection to VSM Server (Or click the Network button (No. 11, Figure
1-2) and select Connect to VSM.)
� Twin Server: Allows connection to Twin Server at startup. (Or click the Network button (No. 11,
Figure 1-2) and select Twin Server). For more details, see Twin DVR System in Chapter 11.
� Connect to CenterV2: Allows connection to CenterV2. (Or click the Network button (No. 11,
Figure 1-2) and select Connect to CenterV2.)
� Enable DirectDraw Overlay: Applies DirectDraw Overlay to enhance image quality if your VGA
card supports it. For certain VGA cards, DirectDraw Overlay can result in blurred images. To avoid
the image problem and remain DirectDraw Overlay, change the image quality from High to
Standard. See Image Quality of DirectDraw Overlay in System Tools later in this chapter.
� Enable De-interlace Render: Avoids interlace of the odd and even video lines. This feature
affects only single view mode with the resolution of 640 x 480 and 704 x 480. After enabling the
feature, you must restart the GV-System to apply it.
11