Manual - Surveillance System, Security Cameras, and CCTV ...

44
1.4.2 Associate Monitoring
You can set camera channels to start recording when any of the associated camera channels begins
recording.
1. Click the Configure button (No. 14, Figure 1-2), select General Setting, select System
Configure, and click the Camera Record Setting tab. This dialog box appears.
Figure 1-29
2. From the Rec Video drop-down list, select either Motion Detect or Day-Night. If you select
Day-Night, remember to click the Arrow button beside to configure the time spans and also set
the recording mode to be Motion Detect.
3. Click the Arrow button on the right of Motion Sensitivity, and select Motion Detection
Associated Group. This dialog box appears.
Figure 1-30
4. Select the camera channels you wish to be associated with the current camera. In this example,
Camera 1 is being configured and it cannot be selected, so it is grayed out. Cameras 2 and 3 are
selected to be associated with Camera 1.
5. Click OK to apply the settings.
From the example (Figure 1-30), whenever Camera 2 or 3 starts recording, Camera 1 will also begin
recording.