Samsung SF-3100I - User Manual_2.42 MB, pdf, ENGLISH

The Fax Machine
Sending a Fax
Automatically
To send a fax automatically, you must have already stored
numbers into either One-Touch button or two-digit Speed Dial
locations, or Group Dial. To learn how to register One-Touch
Dial, Speed Dial, or Group Dial, see “Automatic Dialling” on
page 2-1.
1 Load your document(s) top down in the
document tray with the printed side facing away
from you (up to 15 pages).
2 Select the One-Touch button, Speed Dial
location, or Group Dial location which has the
number(s) you want.
•If a document is loaded when the remote fax machine
answers, the machine scans the document into memory
and begins to transmit. You can check that a fax
has been received by pressing OHD/V.Req to talk after
a transmission.
•For more information on the Voice Request feature, see
“Voice Request” on page 3-11. When the last page of
your document has been sent successfully, the
machine beeps and returns to Standby Mode.
•If something went wrong during your transmission,
an error message appears in the display, see “LCD
Error Messages” on page 7-13. Press Stop to clear the
message and try to send the document again. You can
set your machine to print out a Sending Confirm
automatically. For more information, see “User
Reports” on page 6-5.
Chapter 3
Automatic Redial
When you send a fax, if the number you have dialled is busy
or there is no answer, the machine will attempt to redial the
number every three minutes up to two times.
Before redialling, the display shows ‘RETRY REDIAL?’ to
ask if you want to redial the number or not.
If you want to redial the number immediately:
1 Press Start/Enter when ‘RETRY REDIAL?’
appears in the display.
2 Press Stop to cancel redialling.
The machine returns to Standby Mode.
3-5