Alesis Micron Owners Manual.pdf - Fdiskc

Troubleshooting
If you experience problems while operating your Micron, please
use the following table to check for possible causes and solutions
before contacting Alesis customer service for assistance.
Symptoms Cause Solution
The display does not light up
when the ON/OFF switch
is turned on.
No power. Check that the power
adapter is plugged in
properly.
No sound. Bad Connections. Check your audio cables; if
necessary, swap cables.
Notes sustain continuously.
Notes played from Micron
have a “doubled” or
“flanged” sound
Tempo cannot be controlled
from within the Micron.
Volume is turned down. Raise the Volume knob or
Exp pedal.
Local keyboard is disabled. In the config menu, Set Local
Control to “on.”
External MIDI device sent
Volume (CC#7) or
Expression (CC#11)
commands with a value
approaching 0.
Sustain pedal was plugged in
after power was turned on.
Stuck notes due to
incomplete MIDI data.
Local Control is set to “on,”
and MIDI echo/Thru is
enabled on external MIDI
Change Setups to revert to
default values.
Re-transmit higher values
from MIDI device.
Turn the unit’s power off,
wait a moment, and then
turn it on again.
Press the [programs] button
twice in quick succession
(double-click).
In the config menu, Set Local
Control to “off.”
device or computer. Disable MIDI echo/Thru
on external MIDI device.
MIDI sync is set to “on.”
In the config menu, Set MIDI
sync to “off” or “gen MIDI
clock.”
Alternatively, ensure that any
external devices are not
sending MIDI sync
information to the Micron.
119