Continental L-Head Overhaul Manual - Igor Chudov

More documents

Recommendations

Info

Clutches -- Use a high temperature bearing grease. Do not. over-lubricate. Conventional Transmissions -- For the greatest efficiency over the life of the transmission, use a high quality straight mineral oil. The oil should be changed sea:sonally. Use the following proper grades : Clark Fuller Twin Disc Warner SUMMER SAE 90 SAE 140 SAE 4O SAE .140 CONTINENTAL L-HEAD ENGINE MANUAL Page 15 WINTER SAE 90 SAE 90 SAE 40 SAE 90 Torque Converters and Hydraulic or Automatic Transmissions---These units employ a fluid medium to transmit power which must be very stable Figure 22A F600 Engine with a Hydraulic Coupling to resist formation of harmful deposits or change in body in use. The correct fluid must be selected to obtain maximum efficiency of the transmission. All fluids should be changed seasonally. Type "A" Automatic Transmission fluid is most widely used. There are many widely distributed brands of this type. For some models of Twin Disc Clutch Company’s torque converters, a Special Fluid having a viscosity of 35 Saybolt seconds @ 100 ° F. is, required -other models use SAE 10W engine oil. The Special low viscosity fluid may be obtained from Twin Disc Clutch Company Dealers. To satisfy the SAE 10W requirement, we recommend the use of MS type oils. Allison Division torque converters and Torqmatic transmissions require a type C fluid.
Page 16 CONTINENTAL L-HEAD ENGINE MANUAL TRANSMISSION AND CONVERTER LUBRICATION RECOMMENDATIONS The following grades are generally recommended for hydraulic torque converters and transmissions for Summer and Winter operation: MANUFACTURER <strong>Continental</strong> Motors Corp. Co-Matic Drive Fluid Coupling HC15 Clark Equipment Co. Torcon (converter only) Torcon Converter and Transmission Fuller Mfg. Co. Torque Converter Borg-Warner Borg & Beck & Long Mfg. Co. All converters and hydraulic transmissions Allison Division Torque Converters and Torqmatic Transmissions SUMMER Type A Type A SAE 10W Type A SAE 10W Type A WINTER Type A Type A Type C Type C Twin Disc Clutch Co. Hydraulic Reverse Gears Coupling or Power Take-off SAE 10W SAE 10W Hydraulic Converter Transmissions Input shaft & impeller bearings (C, FC) Same as Engine Type A (below 10 ° F.) Type A Type A (below ° F.) Type A Fluid Medium Special Twin-Disc Fluid except Two speed transmission and converter transmission (Models T-DRR-FT-IT) combinations Type A Type A Reverse Transmissions Models RR-CRR-ICRR SAE 40 SAE 20 NOTE: For all Grease applications on the above units a good high temperature grease should be used.
Page 1 and 2: CONTINENTAL L-HEAD OVERHAUL MANUAL
Page 3 and 4: QUICK REFERENCE SECTION INDEX First
Page 5 and 6: SECTION VII ~ IGNITION CONTINENTAL
Page 7 and 8: Page 2 CONTINENTAL L-HEAD ENGINE MA
Page 11 and 12: SIX CYLINDER L-HEAD ENGINES* M 0 D
Page 15 and 16: Page 10 CONTINENTAL L-HEAD ENGINE M
Page 19: Page 14 CONTINENTAL L-HEAD ENGINE M
Page 29 and 30: P~ge 24 CONTINENTAL L-HEAD ENGINE M
Page 47 and 48: Page 49~ CONTINENTAL L-HEAD ENGINE
Page 57 and 58: Page 51A DISTRIBUTOR 14- WIRE-RED I
Page 59 and 60: Page 51C Full Charge Hydrometer Tes
Page 71 and 72:
Page 62 CONTINENTAL L-HEAD ENGINE M
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
LIMITS AND CLEARANCE DATA Engine Mo
Page 89 and 90:
Page 91:
SERVICE AND PARTS Available from yo
show all

Continental L-Head Overhaul Manual - Igor Chudov

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?