Spectre GCR Manual Manuals - Atari Documentation Archive

Spectre Menus
& . .. ..
not have the option of creating a double sided MFS or single sided HFS
floppy; neither of these is necessary with the 128K ROMS!
DCFormatter, included on the Spectre disk, has an option to format
an 800K MFS floppy, if you need it.
Incidentally, because memory was so tight in 832K mode after
adding support for the CCR, we were forced to remove support for the
Translator One to make room. We didn't know this was going to be
• Driye A
0 Driye B
• Single sided
0 Double sided
• Spettre
0 Hat
Duit I forMat I
Figure 12
necessary until right before the CCR was to be released. (We started
getting the 01' out-of-memory errors.) It's impossible to use the CCR
and Translator One at the same time anyway, since they'd fight over
the disk drives. If you badly need to use the Translator, just drop back
to an earlier version of the Spectre, like 1.9F, to do your translating.
Duplicate: This submenu gives you a convenient way to clone a
Spectre (modified ST) or Mac (CCR ) disk. (see Figure 13)
You select the "from" drive (the source diskette) and the "to"
drive (the destination diskette). If these are the same, you'll be
prompted to switch diskettes as necessary.
You also select the disk type you are copying, either Spectre (ST)
or Mac (GCR). The Mac mode is only available if you are using the
84