SAS(R) 9.1.3 Companion for z/OS

Universal Printing Testing Printer Properties 151
character-set
specifies the character set to use for printing. Valid values are listed in the Printer
Properties window, under the Font tab. If the font does not support the specified
character set, the default character set is used. If the default character set is not
supported by the font, the font’s default character set is used.
NAMED printer-name
must match exactly the name shown in the Print Setup window (except that the
printer name is not case sensitive). If it is more than one word, the printer-name
must be enclosed in double quotation marks.
DEFAULT
is the current default printer if you do not specify another printer.
ALL
updates the font information for all installed printers.
Setting Page Properties
1 Select File Page Setup or
2
Issue the command DMPAGESETUP.
From the Page Setup window, make selections that will apply to the pages printed
for the remainder of your SAS session or until the values are changed again
through this window or through specification of options.
The selections that you can make in this window correspond to options that can be set
by submitting an OPTIONS statement. These options are listed in the following table:
Table 7.1 Options That Control Page Setup
General Options Paper Margins Other
BINDING PAPERDEST TOPMARGIN ORIENTATION
COLLATE PAPERSIZE RIGHTMARGIN
DUPLEX PAPERSOURCE LEFTMARGIN
COLORPRINTING PAPERTYPE BOTTOMMARGIN
Changes made by issuing the above options on an OPTIONS statement remain in
effect for the current SAS session only. Changes made through the Page Setup window
remain in effect for subsequent SAS sessions.
Options not supported by your default printer are dimmed and are not selectable.
Testing Printer Properties
1 Select File Print Setup or
2
Issue the command DMPRTSETUP.
Select a printer from the Printer list box.
3 Select Print Test Page.