SAS(R) 9.1.3 Companion for z/OS

528 WTOUSERROUT= System Option Chapter 18
3 “WTOUSERMCSF= System Option” on page 527
WTOUSERROUT= System Option
Specifies a WTO DATA step function routing code
Default: 0
Valid in: configuration file, SAS invocation
Category: System Administration: INSTALLATION
PROC OPTIONS GROUP= INSTALL
z/OS specifics: all
Syntax
WTOUSERROUT=n
n specifies the routing code. The valid values of n are from 0 to 16.
Note: Specifying a value of 0 for the WTOUSERROUT= system option disables the
WTO function. R
Details
The routing code is assigned to any message that is sent with the WTO DATA step
function or CALL routine. Refer to the IBM documentation for supported routing code
values and their meaning.
Note: Unlike z/OS, SAS does not support multiple descriptor codes. R
See Also
XCMD System Option
3 “WTO Function” on page 276
3 “CALL WTO Routine” on page 250
3 “WTOUSERMCSF= System Option” on page 527
3 “WTOUSERMCSF= System Option” on page 527
Enables the use of operating environment commands in a SAS session
Default: XCMD
Valid in: configuration file, SAS invocation
Category: Input Control: INPUTCONTROL
PROC OPTIONS GROUP= INPUTCONTROL
z/OS specifics: all
Syntax
XCMD | NOXCMD