DC 6130 / P / 6135 / 6230 / 6235 - TA Triumph-Adler GmbH

LDAP Security
8-140
Default Setting (System Menu)
Select the communication protocol according to the type of security employed by the LDAP server. The default setting
is Off.
NOTE: LDAP must be set to On in Protocol Detail on page 8-132.
The table below shows the available settings.
Item Description
Off Do not use security employed by the LDAP server.
SSL/TLS Encryption is applied any data communication. To enable LDAP security, the
LDAP port may have to be changed according to the server settings.
Typically, 636* for SSL/TLS is well-known LDAP port.
STARTTLS Encryption is applied any data communication. Typically, 389* for
STARTTLS is well-known LDAP port.
* You can change the port number using Embedded Web Server.
Use the procedure below to make the setting.
Sys. Menu/Count.:a b
1 Report
2 Counter
*********************
3 System
[ Exit ]
Login User Name: L b
*******************
Login Password:
[ Login ]
System: a b
*********************
1 Network Setting
2 I/F Block Set.
3 Security Level
[ Exit ]
Network Setting: a b
*********************
7 Secure Protocol
8 Host Name
9 LAN Interface
[ Exit ]
1 In the Sys. Menu/Count. menu, press the or key to
select [System], and press the OK key.
A login screen will appear. Then, enter the user ID and
password with administrator privileges to log in, and
press [Login] (the Right Select key).
2 The System menu appears.
3 Press the or key to select [Network Setting].
4 Press the OK key. The Network Setting menu appears.