WAP-V6000 INSTRUCTION MANUAL - TEAC Europe GmbH
WAP-V6000 INSTRUCTION MANUAL - TEAC Europe GmbH
WAP-V6000 INSTRUCTION MANUAL - TEAC Europe GmbH
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Start-Up<br />
Follow these steps to start-up your <strong>WAP</strong>-<strong>V6000</strong><br />
Turn on the TV Screen. Set the video sources selector on your TV to match the<br />
connection from your <strong>WAP</strong>-<strong>V6000</strong>. For example, if you used HDMI, set the TV to<br />
use “HDMI” Input.<br />
1. Turn on <strong>WAP</strong>-<strong>V6000</strong>. The LED on the front panel of the <strong>WAP</strong>-<strong>V6000</strong> lights<br />
up to show that it is powered on.<br />
2. Check the TV display. The default display of <strong>WAP</strong>-<strong>V6000</strong> is<br />
Composite(CVBS). If you use HDMI, take the remote control and push<br />
OUTPUT Key. You can cycle through the TV modes to get the appropriate<br />
display output.<br />
3. Wait a few seconds for the start up page to show up, and it will turn into the<br />
Main Menu.<br />
The start up page will last for only few seconds, and then go to the Main Menu. If<br />
there is still no video output after the start up page appears, please make sure the<br />
<strong>WAP</strong>-<strong>V6000</strong> and the TV are in the same mode. If not, please cycle through the<br />
OUTPUT key on the remote control, wait few seconds during each cycle to establish<br />
the next mode.<br />
12
Change language