Programmer's Manual TSP700/800 Series - i-POS.nl BV

FUNCTION
Sets the magnification rate in character height.
CODE “h” n
HEX 1B 68 n
REMARKS Prints the subsequent data magnified in character height by a rate
specified by the value of n.
n Character height n Character height
0 Unmagnify 3 Quadruple
1 Double 4 Quintuple
2 Triple 5 Sextuple
The value of n can be set to 0(00H) to 5(05H) or “0”(30H) to
“5”(35H).
FUNCTION
Sets the magnification rates in character width and height.
CODE “i” n1 n2
HEX 1B 69 n1 n2
REMARKS Prints the subsequent data in the size specified by n1, n2.
n1 indicates the height magnification and n2 indicates the width
magnification.
n1 (n2) = 0 Normal height (or width) size.
1 Double height (or width) size.
2 Triple height (or width) size.
3 Quadruple height (or width) size.
4 Quintuple height (or width) size.
5 Sextuple height (or width) size.
The values of n1, n2 are 0(00H) to 5(05H) or “0”(30H)” to
“5”(35H).
FUNCTION
Underlining
CODE “–” n
HEX 1B 2D n
REMARKS When the value of n is 1, underlines the subsequent data including
a character spacing set by n.
The part to be skipped by the horizontal tab setting and the block
graphic characters are not underlined.
Resets the underline mode when the value of n is 0.
The value of n can be set to 0(00H) or “0”(30H), or 1(01H) or
“1”(31H).
– 13 –
LINE MODE