Programmer's Manual TSP700/800 Series - i-POS.nl BV

LINE MODE
2) Use N=3 for folloing settings
n1 :Character table
n2 :Character table
n3 :Print column
n4 :Line feed, CR code
Setting 0 1 2 3
n1
n2
Character table See the table 1 (Nest page)
n3 Print colum 69 (TSP800) 55 (TSP800)
33/35/48/53 27/28/38/42 – –
(TSP700) (TSP700)
n4 Line feed (mm) 4 3 4 3
CR code Invalid Invalid Valid Valid
Note: In order to enable the changed memory switch setting, turn
the printer OFF and ON again or send the printer reset
command (“?”) to the printer.
3) Use N=4 for folloing settings (TSP700 only)
Setting 0 1 2 3
n1 Always “0” -
n2 Always “0” -
n3 Print colum See bolow (ESC/POS mode only)
n4 Print area See bolow
n3 Print colum Print area Left margin Font-A Font-B
0 EPSON 72 mm (576dots) 32 dots 42 colums 56 colums
compatible 52.5 mm (420dots) 24 dots 31 colums 41 colums
80 mm (640dots) 40 dots 47 colums 63 colums
50.8 mm (406dots) 24 dots 30 colums 40 colums
1 Max. 72 mm (576dots) 0 dot 48 colums 64 colums
colum 52.5 mm (420dots) 0 dot 35 colums 46 colums
80 mm (640dots) 0 dot 53 colums 71 colums
50.8 mm (406dots) 0 dot 33 colums 45 colums
n4 Print area Roll paper width
0 72 mm (576 dots) 80 mm
1 52.5 mm (420 dots) 58 mm
2 80mm (640 dots) 82.5 mm
3 50.8 mm (406 dots) 58 mm
– 38 –