Programmer's Manual TSP700/800 Series - i-POS.nl BV
Programmer's Manual TSP700/800 Series - i-POS.nl BV
Programmer's Manual TSP700/800 Series - i-POS.nl BV
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
PAGE MODE<br />
Other commands<br />
FUNCTION Print Label<br />
CODE “I” <br />
HEX 1B 49 0A 00<br />
REMARKS This command prints out one label according to the previously<br />
defined format and data.<br />
When print start position detect is ON, the paper will be fed to the<br />
next print start position after printing.<br />
If unrecoverable error occurs during printing, a series of these<br />
operation will be repeated after the printer recovers from the error<br />
condition.<br />
FUNCTION Print Label<br />
CODE “W s1s2s3s4 , h1h2h3h4” <br />
HEX 1B 57 s1s2s3s4 2C h1h2h3h4 0A 00<br />
REMARKS This command prints out the data within the defined print area.<br />
Print area defined by “D” is ignored.<br />
When print start position detect is ON, the paper will be fed to the<br />
next print start position after printing.<br />
If unrecoverable error occurs during printing, a series of these<br />
operation will be repeated after the printer recovers from the error<br />
condition.<br />
s1s2s3s4 : Print start position in the Y direction (unit: 0.1 mm)<br />
h1h2h3h4: Print length from the print start position (unit: 0.1<br />
mm)<br />
– 58 –
Change language