Programmer's Manual TSP700/800 Series - i-POS.nl BV

3-2. Command Specification
Format Definition
FUNCTION Clear format
CODE “C”
HEX 1B 43 0A 00
REMARKS When the printer receives this command, all defined format and
image data are cleared.
The format defined by the following commands will be cleared.
“D”
“E” “L” “PC” “PB”
“Y” “RC” “RB” “Q”
“H” “K” “B”
FUNCTION
Define print area
CODE “D n1n2n3n4”
HEX 1B 44 n1n2n3n4 0A 00
REMARKS This command defines the print area(page length) according to the
value of n1n2n3n4 in 1/10 mm unit.
n1n2n3n4 :Print area 0001 to 2000 (0.1 mm to 200 mm)
Note : When a value greater than the size of the label is set,
two or more labels are assumed to be one label.
For example, when 50 mm is set for a label whose
pitch is 40 mm, one print pattern is printed using two
labels.
To avoid such a case, approx. 5 mm of each top and
bottom margins should be considered.
ABCD
EFG
ABCD
EFG
40 mm
– 47 –
ABCD
EFG
ABCD
EFG
50 mm
PAGE MODE