Programmer's Manual TSP700/800 Series - i-POS.nl BV

FUNCTION Store dot graphic data into image memory
CODE “Q n x1x2x3x4 , y1y2y3y4 ,
h1h2h3h4 , w1w2w3 ,n11n12n13n.…n1k
.…nm1nm2.…nmk”
HEX 1B 51 n x1x2x3x4 2C y1y2y3y4 2C
h1h2h3h4 2C w1w2w3 2Cn11n12n13n.…n1k
.…nm1nm2.…nmk” 0A 00
REMARKS This command stores graphic data into image memory.
n : “;” : OR mode
“:” : Overwrite mode
x1x2x3x4 : Print start position in the X direction. (0000 to 1040 ×
0.1 mm)
y1y2y3y4 : Print start position in the Y direction. (0000 to 2000 ×
0.1 mm)
h1h2h3h4 : Defines the length (Y direction) of the graphic area.
(0001 to 1600 dots)
w1w2w3 : Defines the width (X direction) of the graphic area.
(001 to 104 dots)
n11.…nmk: n11 represents data in the 1st line. Each line ends with
.
Data (X direction) appears in the same way as bit
image data. n21 represents data in the 2nd line.
Note: a) This command can be used any number of times.
b) Size of graphic data is set in 1 mm units (byte units
(8 bits/bytes)) in the X direction and 0.125 mm units
(dot units) in the Y direction.
c) “X” cancels data that was set using the
command.
d) If “;” or “,” is missing, printer goes into an error
condition.
– 55 –
PAGE MODE