Programmer's Manual TSP700/800 Series - i-POS.nl BV
Programmer's Manual TSP700/800 Series - i-POS.nl BV
Programmer's Manual TSP700/800 Series - i-POS.nl BV
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
APPENDIX<br />
Appendix 2 : Sensor adjustment mode<br />
(1) No paper / Black mark sensor adjustment<br />
Operation procedure<br />
1) Select sensor adjustment mode with DIP switch setting.<br />
2) Turn the power ON.<br />
3) With the paper roll installed, turn and adjust VR2 until both POWER /<br />
ERROR LEDs light.<br />
4) Turn the power OFF.<br />
5) Select standard mode with DIP switch setting.<br />
(2) Near-end sensor adjustment<br />
Operation Procedure<br />
1) Select sensor adjustment mode with DIP switch setting.<br />
2) Turn the power ON while holding FEED switch pushed (POWER LED<br />
will lights), then release FEED switch immediately.<br />
3) With the paper roll uninstalled, turn fully VR1 counterclockwise.<br />
If ERROR LED lights, adjustment is not necessary.<br />
If not, adjust VR1 until both POWER / ERROR LEDs light.<br />
4) Install the paper roll and confirm that o<strong>nl</strong>y POWER LED lights.<br />
5) Turn the power OFF.<br />
6) Select standard mode with DIP switch setting.<br />
– 84 –