Programmer's Manual TSP700/800 Series - i-POS.nl BV

PAGE MODE
FUNCTION Set bar code data
CODE “R B n1n2 ; a1a2.…an”
HEX 1B 52 42 n1n2 3B a1a2.…an 0A 00
REMARKS This command defines the bar code data to be printed.
n1n2 : Two digits reference number of defined bar code
whose print position and type are previously defined
with “PB”.
a1a2.…an : Bar code data to be encoded and printed.
Note: a) Start and stop characters of CODE 39 is automatically
inserted.
b) Check word of JAN, EAN, or UPC is automatically
calculated and inserted.
c) When data length does not meet the specifications of
JAN, EAN, or UPC, data length is ignored.
d) CODE 128 conforms to EAN-128; the start code,
check word, and stop code of CODE 128 are automatically
inserted.
e) Start, stop and check characters of CODE 93 are
automatically inserted.
f) Start and stop characters of Interleaved 2 of 5 are
automatically inserted.
g) When the number of digits of lnterleaved 2 of 5 is an
odd number, “0” is automatically inserted as the
highest digit.
h) If “;” is missing, printer goes into an error condition.
– 54 –