Programmer's Manual TSP700/800 Series - i-POS.nl BV

Print Data Settings
FUNCTION Set character string data
CODE “R C n1n2 ;a1a2.…an”
HEX 1B 52 43 n1n2 3Ba1a2.…an 0A 00
REMARKS This command sets character strings defined by the
“PC”.
n1n2 : Two digit reference number of character string whose
print position and type are previously defined with
“PC”.
a1a2.…an : Character string data (up to 100 characters)
Note: a) The same reference numbers used by the format
definition command “PC” is used.
b) To print data, the Print Label command ( “I”)
must be sent.
c) This command, along with the Print Label command
( “I”), allows reprinting of labels where only
the character string data changes.
d) If “;” is missing, printer goes into an error condition.
– 53 –
PAGE MODE