Programmer's Manual TSP700/800 Series - i-POS.nl BV
Programmer's Manual TSP700/800 Series - i-POS.nl BV
Programmer's Manual TSP700/800 Series - i-POS.nl BV
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
PAGE MODE<br />
FUNCTION<br />
Define ruled line format<br />
CODE “L n1n2 ; x1x2x3x4 , y1y2y3y4 , x5x6x7x8 ,<br />
y5y6y7y8 , d , w” <br />
HEX 1B 4C n1n2 3B x1x2x3x4 2C y1y2y3y4 2C x5x6x7x8 2C<br />
y5y6y7y82C d 2C w 0A 00<br />
REMARKS This command defines ruled line format.<br />
n1n2 : Line number(00 to 63)<br />
x1x2x3x4 : Position of the starting point in the X direction (0000<br />
to 1040 × 0.1 mm)<br />
y1y2y3y4 : Position of the starting point in the Y direction (0000<br />
to 2000 × 0.1 mm)<br />
x5x6x7x8 : Position of the ending point in the X direction (0000<br />
to 1040 × 0.1 mm)<br />
y5y6y7y8 : Position of the ending point in the Y direction (0000<br />
to 2000 × 0.1 mm)<br />
These four parameters work in 1/10 mm unit, and should be given<br />
with four digit numbers.<br />
d : Line direction d=0 : Horizontal line<br />
d=1 : Vertical line<br />
When d=0, then y1y2y3y4 = y5y6y7y8. When d=1,<br />
then x1x2x3x4 = x5x6x7x8.<br />
w : Line width 1 to 9 dots<br />
Note: a) This command is used to define lines for label framing.<br />
b) Up to 64 lines can be defined.<br />
c) Lines must be vertical or horizontal (no diagonal<br />
line).<br />
d) The width of one dot is about 0.125 mm, and so four<br />
dots make 0.5 mm width.<br />
FUNCTION Cancel ruled line format<br />
CODE “E n1n2” <br />
HEX 1B 45 n1n2 0A 00<br />
REMARKS This command cancels the line previously defined by “L<br />
n1n2”.<br />
n1n2 : Line number (00 to 63)<br />
– 48 –