Programmer's Manual TSP700/800 Series - i-POS.nl BV
Programmer's Manual TSP700/800 Series - i-POS.nl BV
Programmer's Manual TSP700/800 Series - i-POS.nl BV
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
LINE MODE<br />
Commands to Set the Page Format<br />
FUNCTION<br />
Set page length in lines<br />
CODE “C” n<br />
HEX 1B 43 n<br />
REMARKS Sets the page length using the current line spacing, where n is<br />
between 1 and 127.<br />
Changing the line spacing later does not alter the physical page<br />
length.<br />
The current line becomes the top of the page.<br />
Resets the bottom margin.<br />
Invalid when start position detect is ON.<br />
FUNCTION Set page length in inches<br />
CODE “C” n<br />
HEX 1B 43 00 n<br />
REMARKS Sets the page length to n × 24 mm, where n is between 1 and 22.<br />
Changing the line spacing later does not alter the physical page<br />
length.<br />
The current line becomes the top of the page.<br />
Resets the bottom margin.<br />
Invalid when start position detect is ON.<br />
FUNCTION Set bottom margin<br />
CODE “N” n<br />
HEX 1B 4E n<br />
REMARKS Sets the bottom margin to n lines at the current line spacing, where<br />
n is between 0 and 255.<br />
Changing the line spacing later does not alter the bottom margin.<br />
Bottom margin is reset when you change the page length.<br />
Setting is invalid if the printing area on one page is 36 mm or less.<br />
Invalid when start position detect is ON.<br />
– 16 –