Test Plan for Optical Grooming Switches - Light Reading

More documents

Recommendations

Info

PAR#5 OC-48 SH PAR#6 OC-48 SH PAR#7 OC-48 SH Client Interface Name PAR#8 OC-48 SH PAR#9 STM-16 SH PAR#10 OC-48 SH PAR#13 OC-192 SH PAR#16 OC-12 SH PAR#17 GigE LON#18 100MBaseT Los Angeles Interface name Description Interface variant LA#1 SONET OC-48 WDM LA#2 OC-48 LH LA#3 OC-48 SH LA#4 OC-48 SH LA#5 OC-192 SH LA#6 OC-192 SH LA#7 OC-192 VSR Client Interface Name LA#8 OC-48 SH LA#9 OC-48 SH LA#10 STM-64 VSR LA#11 OC-192 WDM New York Interface name Description Interface variant NY#’1 OC-192 VSR NY#2 OC-192 SH NY#3 OC-48 SH NY#4 OC-192 OTN enabled if possible (i.e G709 wrapper) Client Interface Name NY#6 OC-48 SH NY#7 STM-16 SH NY#12 OC-3 SH NY#14 100M BaseT NY#15 GigE London Interface name Description Interface variant LON#1 OC-48 SH LON#2 OC-48 SH LON#3 OC-192 SH LON#4 OC-192 OTN enabled if possible (i.e.G709 wrapper) Test Plan for Optical Grooming Switches 12
Client Interface Name LON#5 STM-16 SH LON#6 OC-48 SH LON#11 STM-64 VSR Table 1: list of interfaces required for trunk interconnects. N.B. SH=Short haul, LH=Long haul, WDM=wavelength division multiplexed specified tuned laser, OTN=Optical Transport Network (developing standards such as ITU-T G.709), VSR=Very Short Reach 10-Gbit/s serial transponder interfaces. Configuration B Test Plan for Optical Grooming Switches This configuration is used to test BLSR/MS-SPRING networks. Note in order to reduce the number of interfaces the supplier has to provide, only 2 fibre BLSR/MS-SPRINGS are tested. If the supplier does not support 2-fibre BLSR/SPRINGS but DOES support 4 fibre BLSR/SPRINGS then they may offer an equivalent network based on 4-fibre BLSR/SPRINGS – with an associated increase in the number of interfaces required. However, the lack of support for 2-fibre BLSR/SPRINGS will be recorded. #1 PAR LON #1 #2 #3 #5 #5 #4 OC-48 2f BLSR STM-64 2f MS-SPRING LA NY Figure 3: Configuration B. Configuration B Unprotected OC-48 #1 #3 #2 #3 #2 #4 #4 13
Page 1 and 2: Test Specification Issue 2.1 (25 Ju
Page 3 and 4: Published by BTexact Technologies -
Page 5 and 6: Introduction Test Plan for Optical
Page 7 and 8: Test Plan for Optical Grooming Swit
Page 11: 4 OC-48s over a WDM Test Plan for O
Page 15 and 16: Major problem during BTexact testin
Page 19 and 20: Expected result: • SONET/SDH test
Page 21 and 22: Other comments: None END OF BLOCK 1
Page 23 and 24: Other comments: None Current route
Page 27 and 28: Protection route. Available resour
Page 37 and 38: SONET/S DH tester NE TCM- No 1 A SO
Page 41 and 42: J0 should remain unaltered. Test Pl
Page 45 and 46: Any other comments: None Test Plan
Page 51 and 52: BLOCK 15. STM-64 MS-SPRING tests TC
Page 57 and 58: BT Commercial Contact: name address
Page 63 and 64:
12. BT Testing Services Test Plan f
Page 65 and 66:
Schedule 1: Personal Non- Disclosur
show all

Test Plan for Optical Grooming Switches - Light Reading

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?