Single-Chip Low Power RF Transceiver for Narrowband Systems ...

More documents

Recommendations

Info

CC1021 Note: Do not place a via underneath CC1021 at “pin #1 corner” as this pin is internally connected to the exposed die attached pad, which is the main ground connection for the chip. 27.1. Package Marking When contacting technical support with a chip-related question, please state the entire marking information as shown below. SWRS045B Page 86 of 89
27.2. Recommended PCB Footprint for Package (QFN 32) CC1021 Note: The figure is an illustration only and not to scale. There are nine 14 mil (0.36 mm) diameter via holes distributed symmetrically in the ground plane under the package. See also the CC1020EMX reference design. 27.3. Soldering Information The recommendations for lead-free reflow in IPC/JEDEC J-STD-020 should be followed. SWRS045B Page 87 of 89
Page 1 and 2:
CC1021 CC1021 Single Chip Low Power
Page 3 and 4:
CC1021 13. Transmitter ............
Page 5 and 6:
2. Absolute Maximum Ratings CC1021
Page 7 and 8:
Parameter Spurious emission, radiat
Page 9 and 10:
Input IP3 Parameter 433 MHz 102.4 k
Page 11 and 12:
4.3. RSSI / Carrier Sense Section P
Page 13 and 14:
4.6. Frequency Synthesizer Section
Page 15 and 16:
4.8. Current Consumption Parameter
Page 17 and 18:
6. Circuit Description RF_IN LNA RF
Page 19 and 20:
Microcontroller configuration inter
Page 21 and 22:
8. Configuration Overview CC1021 ca
Page 23 and 24:
9.1. 4-wire Serial Configuration In
Page 25 and 26:
9.2. Signal Interface The CC1021 ca
Page 27 and 28:
Transmitter side: DCLK DIO “RF”
Page 29 and 30:
f ref f xosc = REF _ DIV + 1 FSK fr
Page 31 and 32:
The DEC_DIV[2:0] bits in the FILTER
Page 33 and 34:
12.5. RSSI CC1021 has a built-in RS
Page 35 and 36: 12.6. Image Rejection Calibration F
Page 37 and 38: Blocker rejection [dB] 65 60 55 50
Page 39 and 40: • Frequency register setting is s
Page 41 and 42: 12.11. Carrier Sense The carrier se
Page 43 and 44: offset. The new frequency must be c
Page 45 and 46: Current [mA] / Output power [dBm] C
Page 47 and 48: CC1021 CC1021 RF_OUT RF_IN C60 L1 A
Page 49 and 50: 868 MHz CC1021 Figure 28: Typical o
Page 51 and 52: 15.2. VCO and PLL Self-Calibration
Page 53 and 54: CC1021 Loop C6 C7 C8 R2 R3 PLL turn
Page 55 and 56: Rese tCC102 0 WakeupCC1020ToRx/ Wak
Page 57 and 58: the "carrier sense" level (programm
Page 59 and 60: Item CL= 12 pF CL= 16 pF CL= 22 pF
Page 61 and 62: LNA_EN and PA_EN are used to contro
Page 63 and 64: frequencies is done through the MAI
Page 65 and 66: 26.1. CC1021 Register Overview CC10
Page 67 and 68: CC1021 INTERFACE Register (01h) REG
Page 69 and 70: CC1021 CLOCK_A Register (07h) REGIS
Page 71 and 72: CC1021 MODEM Register (0Dh) REGISTE
Page 73 and 74: CC1021 VGA1 Register (11h) REGISTER
Page 75 and 76: CC1021 VGA3 Register (13h) REGISTER
Page 77 and 78: CC1021 FRONTEND Register (16h) REGI
Page 79 and 80: BUFF_CURRENT Register (19h) REGISTE
Page 81 and 82: CC1021 TEST1 Register (21h, for tes
Page 83 and 84: CC1021 AFC Register (43h, read only
Page 85: 27. Package Description (QFN 32) CC
Page 89 and 90: 29. General Information CC1021 Docu
Page 91: *All dimensions are nominal PACKAGE
show all

Single-Chip Low Power RF Transceiver for Narrowband Systems ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?