7.8.1.0 - Force10 Networks

Create a route map
Route maps, ACLs, and prefix lists are similar in composition because all three contain filters, but route
map filters are do not contain the permit and deny actions found in ACLs and prefix lists. Route map filters
match certain routes and set or specify values.
To create a route map and enter the ROUTE-MAP mode, use the following command in the
CONFIGURATION mode:
Command Syntax Command Mode Purpose
route-map map-name [permit | deny]
[sequence-number]
The default action is permit and the default sequence number starts at 10. When the keyword deny is used
in configuring a route map, routes that meet the match filters are not redistributed.
To view the configuration, use the show config command in the ROUTE-MAP mode (Figure 244).
Figure 67 Command Example: show config in the ROUTE-MAP Mode
Force10(config-route-map)#show config
!
route-map dilling permit 10
Force10(config-route-map)#
You can create multiple instances of this route map by using the sequence number option to place the route
maps in the correct order. FTOS processes the route maps with the lowest sequence number first. When a
configured route map is applied to a command, like redistribute, traffic passes through all instances of
that route map until a match is found. Figure 68 shows an example with two instances of a route map.
Figure 68 Command Example: show route-map with Multiple Instances of a Route Map
Force10#show route-map
route-map zakho, permit, sequence 10
Match clauses:
Set clauses:
route-map zakho, permit, sequence 20
Match clauses:
interface GigabitEthernet 0/1
Set clauses:
tag 35
level stub-area
Force10#
CONFIGURATION Create a route map and assign it a unique
name.
The optional permit and deny keywords are
the action of the route map. The default is
permit.
The optional parameter seq allows you to
assign a sequence number to the route map
instance.
Route map zakho has two
instances
FTOS Configuration Guide, version 7.8.1.0 117